Accessories

Description

. The tray can hold Micro PLC splitter 1:4, 1:8, 1:16 perfectly.

. It has splice capacity 6/12 splices.

Description

• Hold one 1:16 micro splitter or two 1:8 micro splitter in each tray.

• Meanwhile with splice capacity 6/12 FO

Description

. The tray can hold PLC splitter 1:4, 1:8, 1:16 perfectly.

. It has splice capacity 6/12 splices.

Description

• Fiber splice tray is generally used to hold and protect individual fiber optic splices

Description

Fiber splice tray is generally used to hold and protect individual fiber optic splices

Description

• Suitable for connecting φ0.25–φ0.9 fiber/cable; take advantage of mature V-groove technologies, suitable for single mode and multimode;

• No fixture, operation time less than 1 minute; better performance than the imported products.

Features:

1. No need fusion splicer, high reliability

2. Quick and easy operation

3. Insertion Loss＜1dB, Reflection Loss≥45dB

4. Reusability ＞ 10 times.

Applications

• By the heat, the sleeve can rebuild coating of fiber to provide mechanical strength at the fusion joint area and keep optical transmission properties.

Features and Benefits

• Moisture resistant for environmental protection

• Clear sleeve make it easy to detect splice before shrinkage

• Easily use and avoid any damages to the optical fiber during installation

Working Conditions

• Operating temperature : -55℃~105℃

• Minimum shrink temperature : 60℃

• Minimum fully recovery temperature : 120℃

Applications

 The sleeve is used for repairing the breakage of the cable and the cable’s jacket. It can easily and quickly seal up the damaged outer jacket of the cable and insulate. It is a kind of wraparound sleeve. The range of the selection is wide. It can be used at any situation. The problem of airproof and waterproof can be solved for the fitting of heat-melting adhesive. The repaired cable’s insulation is as the same as the intact.

Applications: 

 Heat-shrinkable protection tubes are used for Low Voltage insulation over lugs and ferrules. Tubes coated on the inside with hot melt adhesive are also used for external protection of joints. On shrinking, the adhesive melts and seals the joint against dust and moisture.

Applications

To seal the cable port of the fiber optic splice closure together with the heat shrinkable tube and realize all kinds of cable branch seal protection.